Your item is no longer available. Below please see similar items.
This item is no longer available.
|
We are offering this item from Silver Smoke Research:
The LIGHTNING BUG An improved Bob Beck Blood Electrifier
We are a New Member to EBay, So we are making some of our retail units available here for auction to build up our Customer base and Feedback rating. Don't Miss Out on this limited time offer of savings, Once they're gone they'll only be listed at full retail. These are built from the finest parts we've been able to find. So GOOD in fact, We offer a 1 year warranty on parts. We don't just build these units, WE USE THEM TOO!!!
Using an electronic technical consultant, we have improved upon the blood purification device, yet it is still built to the exact specifications of Dr. Bob Beck's schematic.
Here is what Dr. Beck Said about his Circuit...
The first section (U1B) of the LM358 dual op-amp is a 54 (2 x 27 Volts peak per cycle) volt peak-to-peak square wave oscillator. The second section (U1A) reverses polarity and provides ±27 Volts DC output of low impedance. This delivers a Bi-Phasic, sharp rise--time output of ~4 Hz (not critical) for the biological cotton--covered stainless-steel (or gold-plated) electrodes saturated with salt water before applying. Sharp rise--time is considered necessary to provide higher odd harmonics to the stimulus, although "rounded" waveforms will feel different.
The third section is a current--limited 27 Volts DC output from a separate jack for rapid generation of excellent ionic/colloidal silver in water. A three minute cycle in 8 Oz. of room--temperature water makes a ~3-5 PPM concentration.
Op-amp section U1B's 4 Hz oscillator frequency is set by C1 and R1 . It is configured as a comparator with hysteresis determined by R2 . Charging and discharging of C1 is done by the 180º out-of-phase signal through R1. R3 and R4 provide a set--point 1/2 the V+ to the comparator. This insures a 50% duty cycle square wave with an amplitude of slightly less than the ~27 Volt supply.
U1A, the second comparator, is used to invert the output of oscillator U1B. A ~54 Volt peak-to-peak signal will be generated between the op-amps due to their outputs being 180º out-of-phase. U1A's current is limited by potentiometer R5 and R7 and is set to individual user's comfort.
The power indicator circuit consists of a bicolor (Red-Green) LED (CR1) and the series combination of two 18 Volt Zener diodes, D1 & D2, with power limited by C2 . This section of the device is automatically disabled when the 3.5 mm plug is inserted into its jack. Therefore the LEDs flash only when batteries sum is over ~21 Volts. If LEDs are dim or extinguished, replace with three fresh 9 Volt Alkaline batteries. C2 used as a limiter allows the LED to flicker on at 1/8 second intervals only as the square wave output reverses polarity.
Users find this newer design highly satisfactory, trouble free and most efficient
It functions on three (3) 9 volt batteries (Not included at this price) . We have tested and inspected every unit and it has passed QC or it will not be sold.
Here is a link to Our E-Store where we have more Pics and info. CHECK IT OUT!
HTTP://store.fastcommerce.com/silversmokeresearch
|
|
We offer these in our store for $149.99 if you'd rather just"buy it now" because you prefer not to wait. Email me here and I'll create a buy it now for you. This price will include shipping, handling and insurance.
Here are some features:
-2 Jacks, 1 for silver generation and 1 for blood purification. - Includes 2 Stainless Steel wrist electrodes. - Includes alligator clip leads to be used with the silver colloid jack. - Easy access to batteries, just loosen the 4 screws holding it together. - Simple on/off switch with flashing LED indicating units operation and function (circuit closes when electrodes are in proper jack. Note, in videos of other units sold on e-bay the LEDs only come on with the leads plugged in(To save the batteries, But if you have these lights on while pulsing, It will cut the voltage to the blood way down meaning you will NOT get the full benefit). These lEDs are supposed to only show proper current switching and indicate voltage in the batteries. If they are dim, replace the batteries. They are to turn off when the leads are plugged in, otherwise, they are using up the voltage that is to electrify the blood. Our unit shuts off the leds when the plug is inserted in the jack). - Use the knob to adjust power level of pulse output. (When beginning use, please start at the minimum setting as the maximum is very strong, you will feel a tingling/pulsing sensation that you must get used to.) - Should be used with alkaline 9 volt batteries, you may also use rechargeable varieties as well. - The unit is lightweight, compact and durable. We use an LED instead of an incandesent bulb in the colloidal silver circuit, which is more sensitive to lower voltage. This provides an indicator as to how conductive your colloidal mixture is and lets you know that it is working.
|
|
Bob Beck's Blood Electrification Device and Protocol:
The Bob Beck Protocol is the Best way to help restore the immune system to its full potential!!
No other electromedicine treatment for cancer is near as effective as the Bob Beck Protocol. It is far better than any Rife Machine, far better than any Multi-Wave Oscillator (MWO), and better than Hulda Clark's.
The reason the Bob Beck Protocol is so absolutely superior to other electromedicine treatments is that it is the direct result of an incredible Re-discovery in medicine.
Two medical doctors, Dr. Kaali and Dr. Lyman, discovered, in 1990, that a small electric current could disable microbes from being able to multiply, thus rendering them harmless. It was, in fact, the greatest medical discovery in the history of medicine because virtually all diseases are caused by, or enhanced by, a microbe. Their Re-discovery was a solution for almost every contagious disease known to mankind.
Dr. Beck, who held a PhD in physics and had 30 years of electromedicine research behind him, found out about the discovery and found a non-invasive way to use their discovery.
His electromedicine machine is called the Blood Purifier or Blood Electrifier. The Blood Electrifier creates a very small alternating electric current (by "alternating" is meant that the polarity changes 4 times a second). The electric current destroys a key enzyme on the surface of a microbe (this is what Kaali and Lyman discovered), and prevents the microbe from multiplying. The body safely excretes the disabled (I.e. Attenuated) microbes because they are not able to "hang on" to any cells.
Bob Beck Protocol
What the Bob Beck Protocol does is disable from multiplying, every microbe in your body. When a microbe that is in the bloodstream is disabled, the body will remove it. For many diseases that is all that is required for a solution.
The Bob Beck Protocol, because it removes all of the microbes from the body (except the microbes inside the cancer cells), allows the person's immune system to be restored. It has been known for many decades that the immune system communicates with electrical signals. It is as if each white blood cell has a radio transmitter and receiver. However, microbes also are electrical in nature and it is possible that it is the electrical nature of microbes that interfere with the abilities of the immune system to communicate with itself.
Bob Beck believed that his treatment, which clearly removes every type of microbe from the body of a person, is a potent way to restore the immune system of that person. He felt that that was a large reason his treatment had been so successful on patients.
Removing all microbes may allow the immune system to restore in quantity many of the 2,000 neuropeptides (nerve proteins), among which are the well-known interleukin and interferon, which are known cancer-fighters.
The bottom line is that with the Bob Beck Protocol it is the immune system which kills the foreign cells. The Bob Beck Protocol helps restores the immune system. |
|
FDA Required Disclaimer This web site is for educational purposes only. It is not intended as a substitute for the diagnosis, treatment and advice of a qualified licensed professional. This site offers people medical information and tells them their alternative medical options, but in no way should anyone consider that this site represents the "practice of medicine." This site assumes no responsibility for how this material is used. Also note that this website frequently updates its contents, due to a variety of reasons, therefore, some information may be out of date. The statements regarding alternative treatments for cancer have not been evaluated by the FDA. These devices are being built and sold for experimental purposes only, I do not claim to be able to cure, diagnose or treat any disease.). |
|
What You Get With The LIGHTNING BUG, a Bob Beck Blood Pulser with silver jack.
2 Stainless Electrodes, 1 set of leads with alligator clips, 4 cotton sleeves & Wrist band.
|
|
It's trouble free and easy to get started:
Plug in the leads and attach to the electrodes, be sure to use cotton sleeves (I provide 4 of my own home made ones), soak them in a sea salt solution: 10% sea salt 90% distilled water, (do not drench them).
Apply the sleeves with the electrodes within them to your ulnar and radial pulse points (diagram below) , Then Wrap with arm band snuggly in place. Make sure that there is no solution between the two electrodes as you'll want the current to go down into your blood, not across your skin surface.
LIGHTNING BUG FUNCTIONS
The Blood Electrifier is comprised of a few key components, I will explain their function, use and operation to get you started utilizing the device to the fullest benefit.
function:
On/ Off- CS mode Switch: Toggles the unit on for blood electrification - Off- CS On for silver generation. Pluse Jack: This is the jack used to insert the leads for electrodes for use on wrist. Current Adjust Knob: Adjust the output current of the device, the far left is the minimum, completely right is the maximum. Silver Colloid Jack: This is the jack used for generating silver colloid (with the alligator clip extensions attached). Bi-Color LED: This is the LED that indicates switching operation and voltage of the unit (Does not flash when electrodes are in electrode jack) Yellow LED: Lights when electrodes + alligator clip extensions inserted into silver colloid jack. Can be tested by touching both ends of the clips to each other, the light will turn on. Will light dimmly as colloid is being generated and increases in intensity as Colloid PPM increase.
For more detailed instructions and information please read Dr. Bob Becks lecture called "Take Back Your Power" search yahoo or goolge for a complete download in PDF format.
*Important Note*: 9v battery connectors are not normally made for multiple batteries. We have used Electrical Butt Splices to connect them in series. While this is very durable, you can still pull them apart if you are not careful. If you do happen to pull them apart you can solder them back or if you prefer to pay shipping BOTH ways, I will be glad to repair it or replace it at our discretion.
We are offering a LIMITED number of these LIGHTNING BUG units here for Auction to build Our presence here on EBay.
Thank you, and have a Healthier day! |
On Sep-05-08 at 14:16:49 PDT, seller added the following information:
|
|